Looking for Chip Sealing in Washington, Missouri?

PROFESSIONAL ASPHALT PAVING

We have been paving St. Louis and the surrounding areas for 30 years. We are a family ran and operated business. We cover all asphalt needs. Give us a call today!

Schedule Your FREE Consultation

Quote Home Form

About Chip Sealing

The first step in getting a Chip Sealing Service is to prepare the surface. Once the surface is prepared, it should be protected from traffic and other damage from all directions. A trained professional should also remove loose gravel before starting the sealing process, as these can damage the new surface. If you choose to have the sealers do the chip sealing process, be sure to hire a company that has experience and expertise in this area. The results will be worth the expense, and your car will look great for many years to come.

Chip seal

A chip sealing service can help you make your pavement look like new again. Chip seals are made from a combination of small stones and a specialized emulsion. When you use chip seals, they must be applied before the binder sets. Brooming too soon can ruin the new surface. Experts at GPM know the best practices to apply chip seals and can help you choose the right type of emulsion for your needs.

Slurry seal

Slurry seal is a type of concrete application on roads. It is usually applied after chip seal has been installed on the road. A distributor truck applies a mixture of asphalt, aggregate, and filler on the surface of the road. A roller then embeds the chips in the pavement. Five days after applying chip seal, the street is swept to remove loose chips. Five days later, a slurry seal application is completed. The mixture is squeegeed by hand to achieve uniformity. In 1999, a typical slurry seal installation cost was $1.20/square yard. The lifespan of a chip seal treatment is four to six years.

Fog seal

To extend the life of fog seals, chip sealing service providers apply emulsified asphalt to roadways. Emulsifiers allow asphalt to remain in a liquid state and prevent excessive heating. This method is especially effective on larger roadway projects. However, the process has disadvantages, including the need for heavy equipment. Here are a few advantages of fog seals. Read on to learn more. This method is a great complement to chip sealing.

Slurry seal vs chip seal

Slurry seals are a good, economical alternative to chip-sealed roads. They can last longer than chip-sealed pavements and don't contain loose aggregate. Slurry seals can withstand turning traffic as well as straight-line traffic, but the difference between these two types of pavements lies in their application. Chip-sealed roads have a more uniform, smooth surface than slurry-sealed roads. Type I slurry contains about an eighth of an inch of aggregate and is typically used in low-wear areas where maximum crack penetration is needed.

Cost of chip seal

While asphalt repaving is a popular option for driveways, the price of chip seal is much less than for asphalt. This is because chip seal requires less material and is cheaper per square yard. However, the price varies considerably from driveway to driveway. Chip seal requires some setup costs, which are proportionate to the size of the job. However, because long, straight sections require less handwork, chip seal costs are much lower.

Maintenance of chip seal

Chip seal is a protective wearing surface that can be applied to new pavements. It can also be applied to aging pavements with surface distress. The chip sealing process slows the aging process of paved roads and reduces the need for frequent resurfacing. Although chip seals are relatively inexpensive, they can pose a few inconveniences to motorists. These may include dust, loose gravel, and one-way traffic. Travelers should also slow down while driving until the loose gravel is completely removed.

About Washington, Missouri

Named after George Washington after it came under American control, the town was first settled during the rule of the Spanish Empire. It was originally called St. John Meyer's Settlement and was the site of the Spanish log fort San Juan del Misuri (1796–1803).

Family and followers of Daniel Boone settled the area across the river from Washington, Missouri starting in 1799. In 1814 a ferry boat was licensed for crossing the Missouri River to the north, and the settlement became known as Washington Landing. In 1827 a town was laid out, with sale of lots starting in 1829. The cost of land was waived if the buyer could build a substantial house within two years. This encouraged many new settlers.

Substantial numbers of anti-slavery German families started moving to the town in 1833, and they soon overwhelmed the existing population of slaveowners. However, many of the original slaveowners' homes still remain throughout the town. Washington became a strong supporter of the Union during the American Civil War. The town was ransacked by Confederate General Sterling Price's soldiers, but they were unable to keep control of the area.

After the war, Washington became a railroad and steamboat transportation center. Its manufacturing industry, while strong, is not as vibrant as it was decades ago.

The town of Washington has 445 buildings on the National Register of Historic Places. Due to its historic charm, Washington has a growing heritage tourism industry, with visitors also attracted to the nearby Missouri Rhineland.

The Washington Bridge was constructed in 1934 and was the only bridge spanning the Missouri River in Franklin County. It was replaced with a new, wider bridge that was opened to traffic on December 3, 2018. The original bridge was demolished on April 13, 2019.

In 1988, the first Walmart Supercenter opened in Washington.

According to the United States Census Bureau, the city has a total area of 9.87 square miles (25.56 km), of which 9.34 square miles (24.19 km) is land and 0.53 square miles (1.37 km) is water. The majority of annual precipitation falls during the humid springs and summers. Typically, fall and winter are relatively dry. While snow is not rare, it is not as frequent as in the upper Midwest. An average of 19 inches falls annually.

The 2020 United States census counted 14,500 people, 5,785 households, and 3,766 families in Washington. The population density was 1,501.0 per square mile (579.5/km). There were 6,203 housing units at an average density of 642.1 per square mile (247.9/km). The racial makeup was 92.21% (13,370) white, 0.61% (89) black or African-American, 0.22% (32) Native American or Alaska Native, 0.79% (114) Asian, 0.12% (18) Pacific Islander, 0.99% (143) from other races, and 5.06% (734) from two or more races. Hispanic or Latino of any race was 1.7% (242) of the population.

Of the 5,785 households, 30.9% had children under the age of 18; 50.3% were married couples living together; 24.6% had a female householder with no husband present. Of all households, 29.3% consisted of individuals and 13.0% had someone living alone who was 65 years of age or older. The average household size was 2.4 and the average family size was 2.9.

22.7% of the population was under the age of 18, 7.5% from 18 to 24, 24.8% from 25 to 44, 24.7% from 45 to 64, and 17.3% who were 65 years of age or older. The median age was 38.6 years. For every 100 females, the population had 92.5 males. For every 100 females ages 18 and older, there were 93.6 males.

The 2016-2020 5-year American Community Survey estimates show that the median household income was $66,779 (with a margin of error of +/- $6,377) and the median family income was $80,056 (+/- $4,419). Males had a median income of $44,859 (+/- $4,169) versus $33,981 (+/- $2,766) for females. The median income for those above 16 years old was $36,920 (+/- $1,560). Approximately, 5.0% of families and 6.5% of the population were below the poverty line, including 13.0% of those under the age of 18 and 4.5% of those ages 65 or over.

As of the census of 2010, there were 13,982 people, 5,863 households, and 3,665 families living in the city. The population density was 1,497.0 inhabitants per square mile (578.0/km). There were 6,319 housing units at an average density of 676.6 per square mile (261.2/km). The racial makeup of the city was 96.7% White, 0.7% African American, 0.1% Native American, 0.5% Asian, 0.1% Pacific Islander, 0.7% from other races, and 1.2% from two or more races. Hispanic or Latino of any race were 2.1% of the population.

There were 5,863 households, of which 31.3% had children under the age of 18 living with them, 48.3% were married couples living together, 10.1% had a female householder with no husband present, 4.0% had a male householder with no wife present, and 37.5% were non-families. 31.9% of all households were made up of individuals, and 14% had someone living alone who was 65 years of age or older. The average household size was 2.35 and the average family size was 2.97.

The median age in the city was 39.4 years. 24.1% of residents were under the age of 18; 8.1% were between the ages of 18 and 24; 24.8% were from 25 to 44; 26.1% were from 45 to 64; and 17% were 65 years of age or older. The gender makeup of the city was 47.8% male and 52.2% female.

As of the census of 2000, there were 13,243 people, 5,258 households, and 3,501 families living in the city. The population density was 1,548.9 inhabitants per square mile (598.0/km). There were 5,565 housing units at an average density of 650.9 per square mile (251.3/km). The racial makeup of the city was 97.76% White, 0.85% African American, 0.13% Native American, 0.42% Asian, 0.23% from other races, and 0.63% from two or more races. Hispanic or Latino of any race were 0.66% of the population.

There were 5,258 households, out of which 32.7% had children under the age of 18 living with them, 53.7% were married couples living together, 9.1% had a female householder with no husband present, and 33.4% were non-families. 28.4% of all households were made up of individuals, and 12.2% had someone living alone who was 65 years of age or older. The average household size was 2.46 and the average family size was .

In the city, the population was spread out, with 25.7% under the age of 18, 8.7% from 18 to 24, 30.3% from 25 to 44, 19.4% from 45 to 64, and 16.0% who were 65 years of age or older. The median age was 36 years. For every 100 females, there were 91.5 males. For every 100 females age 18 and over, there were 88.7 males.

The median income for a household in the city was $43,417, and the median income for a family was $52,433. Males had a median income of $36,163 versus $23,666 for females. The per capita income for the city was $22,360. About 3.0% of families and 5.0% of the population were below the poverty line, including 4.1% of those under age 18 and 4.7% of those age 65 or over.

Related Pages